English
INSTALLATION /WIRE |
|
CONNECTION GUIDE |
|
CONTENTS |
|
1.BEFORE STARTING | 30 |
2.PACKAGE CONTENTS | 30 |
3. GENERAL CAUTIONS | 30 |
4. CAUTIONS ON INSTALLATION | 31 |
5. INSTALLING THE SOURCE UNIT | 31 |
6. REMOVING THE SOURCE UNIT | 32 |
7. CAUTIONS ON WIRING | 33 |
8. WIRE CONNECTIOS | 34 |
1. Before Starting
1. This set is exclusively for use in cars with a negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery“ ”terminal before starting. This is to prevent short circuits during installation. (Figure 1)
2. Package Contents
Source unit | 1 |
Owner’s manual and Installation manual | 1 |
Mounting bracket | 1 |
Machine screws M5x6 mm | 4 |
Mounting bolt (50 mm) | 1 |
Parking wire | 1 |
Removable face plate case | 1 |
Trim plate | 1 |
2 | |
Rubber cushion | 1 |
Remote control unit | 1 |
Battery (CR2025) | 1 |
(Installed in remote control) |
|
3. General Cautions
1. Do not open the case. There are no | 2. Use a soft, dry cloth to clean the case. |
user- serviceable parts inside. If you | Never use a rough cloth, thinner, |
drop anything into the unit during | benzine, or alcohol etc. For tough dirt, |
installation, consult your dealer or an | apply a little cold or warm water to a soft |
authorized Clarion service center. | cloth and wipe off the dirt gently. |
30 | VZ309 |