Blaupunkt IVSC-5502 General Information, General information, Installation and safety notices

Page 3

GENERAL INFORMATION

General information

Thank you for choosing a Blaupunkt product. We hope you enjoy using this new piece of equipment.

Please read these operating instruc- tions before using the equipment for the first time.

The Blaupunkt editors are constantly working on making the operating in- structions clearer and easier to under- stand. However, if you still have any questions on how to operate the device, please contact your dealer or the tele- phone hotline for your country. You will find the telephone number printed at the back of this booklet.

We provide a manufacturer guarantee for our products bought within the Eu- ropean Union. You can view the guar- antee conditions at www.blaupunkt.de or ask for them directly at:

Blaupunkt GmbH

Hotline

Robert Bosch Str. 200

D-31139 Hildesheim

Installation and safety notices

Before connecting your signal control- ler, please read the following informa- tion carefully.

The battery’s negative terminal must be disconnected for the entire time it takes to install and connect this de- vice.

When doing so, observe the vehicle manufacturer’s safety notices (airbags, alarm systems, trip computers, immo- bilizers).

Before drilling any holes, make sure that no installed cables or vehicle compo- nents can be damaged.

When installing the signal controller, select a location in the vehicle that al- lows you to attach it firmly into place using screws. The installation location should be such that the signal control- ler does not get in the way of the driver and cannot endanger the occupants in the event of the vehicle suddenly com- ing to a halt, for instance, during an emergency stop.

The IR remote control should not be in- stalled within the inflation range of air- bags (driver, passenger side, side air- bags) or in any position where it could be struck by the vehicle occupants’ heads or knees.

With regard to the installation location and the attachment using an adhesive pad, check and ensure that the holding strength of the installation surface is sufficient and suitable for all situations and safety requirements.

Accessories

We recommend you use accessories that have been approved by Blaupunkt.

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS DANSK

11

Image 3
Contents IVSC-5502 Contents General information Installation and safety noticesAccessories General InformationSwitching off the signal controller Supplied Parts Switching ON/OFFSwitching on/off Switching on the signal controllerExternal monitor switch Fig SettingsSettings IR remote controlSettings for Audio OUT IR Remote ControlInstallation InstallationSpecifications Installation SpecificationsMonitor outputs Features+12V Ignition +12V Permanent 1 Batterie, battery Masse / GND Front Left Right Overhead 9002/1024 Ivmr 5802/6502 Ivms Blaupunkt GmbH