Installation

Installation

Installation and safety notices

Before connecting your signal control- ler, please read the following informa- tion carefully.

The battery’s negative terminal must be disconnected for the entire time it takes to install and connect this device.

When doing so, observe the vehicle manufacturer’s safety notices (airbags, alarm systems, trip computers, immo- bilizers).

Before drilling any holes, make sure that no installed cables or vehicle compo- nents can be damaged.

When installing the signal controller, select a location in the vehicle that al- lows you to attach it firmly into place using screws. The installation location should be such that the signal control- ler does not get in the way of the driver and cannot endanger the occupants in the event of the vehicle suddenly com- ing to a halt, for instance, during an emergency stop.

The IR remote control should not be in- stalled within the inflation range of air- bags (driver, passenger side, side air- bags) or in any position where it could be struck by the vehicle occupants’ heads or knees.

With regard to the installation location and the attachment using an adhesive pad, check and ensure that the holding strength of the installation surface is sufficient and suitable for all situations and safety requirements.

Note:

Before connecting the monitors to your signal controller, check that the +/- and switching positive connec- tions are working properly.

Positive connection

Connect the fuse holder (1A fuse) to protect the positive cable (permanent (1), see Fig. 1). The fuse holder should be connected to the positive terminal at a distance of max. 30 cm from the vehi- cle battery (if necessary, drill a hole in the bulkhead and use the appropriate cable grommets).

Switching positive

Connect the switching positive cable (2) (see Fig. 1) to the switching positive

output (ignition ) of the main de- vice (e.g. car radio or navigation device). If connecting to terminal 15 of the vehi- cle, protect the switching positive cable

(2)by installing a fuse holder (1A fuse) at a maximum distance of 20 cm from the point of connection.

Fuse

If the fuse needs to be replaced, never bypass/bridge the fuse and never re- place it with fuse types that are designed for higher currents.

Negative (ground) connection

Attach the negative cable (1) (earth/ GND, (3), see Fig. 1) directly to the ve- hicle body using a screw. Scratch the surface down to the bare metal at the point at which the ground is made.

•If the installation requires holes to be drilled or any other changes to be

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS DANSK