Installing and Operating the Canopy
•With the stroller open, clip BOTH sides of the canopy onto the handle tubes just above the retaining blocks, taking care not to catch any material underneath the clips. See Figure 5. Attach the hook and loop tabs at the top of the canopy to the handle tubes.
•Pull both side flaps over the handle tubes and attach the hook and loop material together to hold them in place.
•Place the rear apron behind the seat back and attach the female snap on the bottom of the apron to the male snap on the top of the seat back.
•To open the canopy, pull forward on the front edge of the canopy until it is fully extended. Once the canopy is extended, push down on BOTH side hinges to lock it in the open position. See Figure 6.
•The canopy and visor can be adjusted into several positions ranging from fully closed to fully extended, or any position in between. See Figure 7.
•The visor can be opened (or closed) by pulling (or pushing) it from under the canopy.
•NOTE that the top rear portion of the canopy has a roll back window. To open, pull the forward edge up, roll the flap back, and secure using the elastic loop attachment.
•To close the canopy, unlock both side hinges and push the front edge of the canopy toward the rear of the stroller. See Figure 8.
•To remove the canopy, unsnap the snap on the top of the seat back. Remove both side flaps from their hook and loop attachments. Unfasten the hook and loop tabs from the handle tubes. Pull the clips on the canopy away from the handle tubes. See Figure 9.
Figure 5 | Figure 6 | Figure 7 |
Figure 8 | Figure 9 |
! | WARNING |
Possible pinching hazard - Be careful when closing and opening the side hinges.
Groove Instruction Manual | Page |
