Reattaching the Seat
•Place the seat loosely into the stroller frame.
•Feed the shoulder straps through the appropriate slots of the headrest, and the
•Feed the end of one of the shoulder straps with the metal clip on it through the LOWER slot in the plastic support bracket and then around and back out through the UPPER slot. Secure the strap by feeding it through the slot in the metal clip. Make sure the strap is fully inside the metal clip and then pull on the loose end of the strap to tighten it to the plastic bracket. Repeat for the shoulder strap on the other side. Be certain BOTH shoulder straps are securely fastened and not twisted.
•Fit the pockets on the back of the seat over the two upright seatback support posts.
•Feed the crotch strap down through the
•Feed the ends of both waist straps through the slots in the
•Loop the end of one waist strap around the upright frame tube JUST BELOW the large plastic side panel. Secure the strap by feeding it through the slot in the metal ring. Repeat for the waist strap on the other side. Be certain BOTH waist straps are securely fastened and not twisted.
•Fit the pockets on the underside of the front of the seat over the leg support posts on BOTH sides.
•Reattach the two snaps on the bottom of the seat.
•Reattach the upper rear seat straps on both sides by snapping them to the curved upright frame tubes.
•Reattach the two seat side flaps by looping the flap over the top of the frame tube and snapping into place BOTH snaps for each flap. Be sure the hook and loop material faces outward.
!WARNING
BEFORE PLACING YOUR CHILD INTO THE SEAT
Recheck all snaps and metal clips for proper and secure attachment.
Be certain that all straps and snaps are securely engaged.
Be sure that straps are not twisted.
Groove Instruction Manual | Page 11 |
