Installation, Installing the unit | Boss Audio Systems 620UA

DIN REAR-MOUNT (Method B)

If your vehicle is a Nissan, Toyota, follow these mounting instructions.

Use the screw holes marked T (Toyota), N (Nissan) located on both sides of the unit to fasten the unit to the factory radio mounting brackets supplied with your vehicle.

Side View showing Screw Holes marked T, N or S

Screw

Factory Radio Mounting Bracket

Screw

Dashboard or Console

To fasten the unit to the factory radio mounting brackets.

Align the screw holes on the bracket with the screw holes on the unit, and then tighten the screws (5x5mm) on each side.

Note: the outer trim ring, sleeve and the metal strap are not used for method B installation.

Removing the unit

Insert both of the supplied keys into the slots at the middle left and right sides of the unit, then pull the unit out of the dashboard.

After inserting the holder into the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place.

INSTALLATION

Notes:

yChoose the mounting location where the unit will not interfere with the normal driving function of the driver.

yBefore fastening the unit to the vehicle make sure all function are operating properly.

yUse only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.

yConsult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.

yInstall the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop.

yAvoid installing the unit where it would be

subject to high temperature, such as from direct sunlight or hot air from the heater.

DIN FRONT-MOUNT (Method A)

Installing the unit

(1)Metal Strap

Be sure to use the strap to secure the back of the unit of the place. The strap can be bent by hand to the desired angle.

(2)Mounting Bolt

(3)Hex Nut

(4)Spring Washer

(5)Tapping Screw

(6)Plain Washer

(a)Dashboard

(b)Holder