Using the TFT Monitor

VM9022HD

Open/Close TFT Monitor

Open TFT Monitor

Press the OPEN button (1) on the front panel or press the () button (25) on the remote control to slide the monitor panel down to reveal the disc and SD card slots.

Close TFT Monitor

Press the OPEN button (1) on the front panel or press the () button (25) on the remote control close the monitor panel.

Monitor Tilt Angle Adjustment

A known characteristic of LCD panels is the quality of the display in relationship to the viewing angle. The monitor angle can be adjusted for optimum viewing using one of the following methods.

Step by Step Angle Adjustment

Press the ( ) or ( ) button on the remote control (26, 27) to adjust the tilt angle of the screen one step at a time.

Continuous Angle Adjustment

Press and hold the ( ) or ( ) button on the control panel or remote control to adjust the tilt angle in a continuous motion.

Reverse Driving Use

If the rear-view video camera is connected, the unit is on, and the monitor is stationed inside the main compartment of the unit, the monitor automatically moves into the viewing position and switches to CAMERA mode upon reverse driving. When the reverse driving stops, the monitor returns to the main storage compartment.

If the monitor is in display mode, the monitor automatically switches to CAMERA mode upon reverse driving. When the reverse driving stops, the monitor returns to its original input mode.

Aspect Ratio

Press the WIDE button (28) on the remote control or WIDE/ PIC button (7) on the monitor to adjust the aspect ratio as follows (only active with video source):

CINEMA

The entire screen is extended horizontally to the aspect ratio of 16 to 9. The extension ratio is the same at any point.

NORMAL

The conventional display image has a 4 to 3 ratio of horizontal to vertical, leaving a blank area on the right and left sides of the display.

STANDBY

Screen becomes black. Touch screen to resume.

Image Setting

Table 2 shows the video output mode for each playing source.

Table 2: Video Output Modes

Playing Source	Video Output Modes


RADIO	RGB Mode

SAT	RGB Mode

DISC	RGB Mode

BT	RGB Mode

AUX 1	CVBS Mode

AUX 2	CVBS Mode

NAV	RGB Mode

CAMERA	CVBS Mode

*CVBS – Composite Video Baseband Signal

Parameter Adjustment Procedure

1.Enter Picture Quality Setting Mode:

Press the PIC button (24) on the remote control or press and hold the WIDE/PIC button (7) on the monitor.

2.Select Item to Set:

Use the up/down joystick buttons to select “BRIGHT” or “CONTRAST”.

3.Set Parameters:

Use the left/right joystick buttons to modify the settings.

4.Exit Picture Quality Setting Mode:

Press the PIC button on the remote control or the WIDE/ PIC button on the monitor

Parking Brake Inhibit

When the pink "Parking" wire is connected to the vehicle Parking Brake circuit, the front TFT monitor will display video when the Parking Brake is engaged. (When the pink wire is grounded via the Parking Brake circuit, video will be displayed.)