Vizualogic A 1250, A 1150 manual Audio Playback, FM Modulator Playback, IR Headphones

Audio Playback

The Vizualogic A-1250 and A-1150 System features multiple ways to enjoy the audio portion of a desired source. The audio can be experienced through the use of Infrared Headphones or with the integrated wireless FM Modulator

FM Modulator Playback

To listen to the audio portion of the viewed source though the vehicle’s

stereo system aim the remote at the driver’s side monitor and simply press the FM SOURCE button to turn the FM modulator on. The screen will now display FM SOURCE: DRIVER DVD. The Audio portion of the source originating from the Driver's side headrest will now be audible through the vehicle's stereo. If a different audible source is desired, press the FM SOURCE button again to select from PASSENGER DVD, EXT AUX, and OFF. Once the desired audible source has been selected, the transmitting frequency the FM modulator transmits on can be changed by pressing the FM FREQ button on the remote. Tune the vehi- cle’s radio to the corresponding station to listen to the source that is displayed on the driver’s side monitor.

To change the transmitting frequency, aim the remote at the driver’s side monitor and press the FM FREQ button. Each press of the button advances the frequency as follows:

FM CH1 88.5MHz4FM CH2 88.7MHz4FM CH3 88.9MHz4FM CH4 89.1MHz4FM CH5 89.3MHz4FM CH6 89.54FM CH7 89.74FM8 89.9

To turn the FM Modulator Off aim the remote at the driver’s side monitor and press the FM SOURCE button repeatedly until FM OFF is displayed.

NOTE: All of the FM Modulator control functions can also be controlled in a similar fashion using the buttons on the front of the monitor.

IR Headphones

The Vizualogic All-In-One System features integrated Infrared (IR) transmitters on the front of each monitor. The driver’s side monitor transmits on channel ‘A’ and the passenger side transmits on channel ‘B’. To listen to the source displayed on monitor, turn on the headphones and select the corresponding audio channel for the monitor being viewed. NOTE: Always adjust volume control on the headphones to the lowest setting before turning them on.

1.POWER OFF-ON – Manually turns the headphones on or off. POWER LED will illuminate while the headphones are on.

2.IR CHANNEL SELECTOR – Switches audio reception between IR Channel A and IR Channel B.

3.POWER LED – Illuminates in red to indicate that headphones are on.

4.VOLUME – Increases or decreases the volume output of the wireless headphones.

16 17