Russound CAM6.6T-S1 instruction manual Learn IR LrnIR, KEY Function f

Select the source (Source 1-6 and Miscellaneous Learned IR (Misc)) whose commands will be learned into the controller.

Select the function to be learned or deleted.

Select Learn IR Now or Delete IR. If Learn IR Now, a “USE REMOTE” prompt appears. Point the learning remote at the controller’s IR window. If Delete IR, procedure returns to LEARNED SRC (step 1)

If “yes,” sends the learned command to the source component to test the IR. If the component responds, the IR test was a success. If the component does not respond the Code was not learned properly. If “no,” menu goes back to LEARNED SRC (step 1)

Asks if the IR test was a success

IF YES - If the test was a success, specify “yes” and proceed to KEY FUNCTION (step 2)

IF NO - If the test was a failure, specify “no” and LEARN/DELETE (step 3) reappears on the display allowing another code to be learned in.

INSTALLER

INSTALLATION MENU

9. KEY FUNCTION (f) –	Select Keypad function.
(KeyFn)

10.SAVE CHANGES? (f) – Select “yes” to save the changes. (Save?)

LEARN IR (LrnIR)

This procedure allows IR commands to be learned into the system and be centrally stored in the main controller to let the system access the same IR codes that operate the source equipment.

NOTE: IR codes must be learned in by pointing the remote at the CAM6.6’s REAR panel IR receiver only. See Learn IR - Flow Chart on page 73

1. LEARNED SRC – (LnSrc)

2. KEY FUNCTION – (KeyFn)

3. LEARN/DELETE – (Ln/Dl)

4. TEST IR? – (TstIR)

5. SUCCESS? - (OK?)

MACRO EDITOR (MacEd)

This procedure is used to create a sequence of commands that are launched with one key touch or other event. Up to 132 macros can be created for the system, and each macro can contain up to 10 commands including other macros and delays. See Macro Editor - Flow Chart on page 74

60