Audiovox 1187001PL guide

4.Carefully pull (3) A/C wire harness clips from roof brace to extend length of wire harness. It may be necessary to lower the driver’s side of headliner at the “B” pillar to gain access to the 3rd clip. See Fig. 4 Use caution when pulling on wire harness and pulling downward on headliner. The connector should reach the rear cut-out in headliner when all clips are released.

FIGURE 4

5. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to the C-pillar. Down the C-pillar to the floor. Route the power lead to a fused accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See Figure 5. Connect per instructions included with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna.

FIGURE 5

6.Using a digital volt meter, check function of lights.

7.Construct a 3' jumper harness that will connect the vehicle’s dome light wires to the lights in video system. Connect the red/black wire from video system to the O.E. yellow/purple wire. Connect the purple wire from video system to the O.E. yellow wire. Connect the black wire from video system to the O.E. pink wire. See Fig. 6.

FIGURE 6