InFocus INF7001A manual Using the Remote

Page 12

USING THE REMOTE

The remote uses two (2) AAA batteries (not included). Install the batteries by removing the cover from the remote’s back, aligning the + and – ends of the batteries, sliding them in place and replacing the cover.

To operate, point the remote at the monitor sensor at the bottom right-hand corner of the monitor. The range of optimum operation is about 26’ (8m) and within a horizontal and vertical angle of 30 degrees.

30˚ 30˚

i

CAUTION:

When disposing of the batteries, be sure to do so in an environmentally proper manner.

If the remote control gets wet, wipe it dry immediately.

Avoid excessive heat and humidity.

Ensure the batteries’ polarity (+/-) is properly aligned.

Do not mix new and old batteries or different types of batteries together.

Replace the batteries as soon as they run out.

Remove batteries from the remote control when storing or not in use for a prolonged period.

Page 10

Image 12
Contents Hardware Guide Page Contents Page Declaration of Conformity TrademarksSafety Considerations INF7001a Hardware Guide Remote control Documentation USB cable VGA cable Power cord WHAT’S Included1920 x 1080 monitor Setup MountingConnecting to Other Devices Connecting AC Power External PC Touchscreen Control SetupTurning the Monitor ON/OFF Using the Remote Remote buttons Using the Keypad Input Menu VOLOSD ON-SCREEN Display Menu System Picture Menu Screen Menu Audio menu PIP menu InputComponent Composite Configuration Sel Adjust Enter Back Advanced Option Troubleshooting Symptom Possible SolutionsPage LED Indicators Near IR sensorSpecifications TFT-LCDLimited Warranty Limited Warranty Periods are as followsAdditional Limitations INF7001a Hardware Guide Customer Self Repair INF7001a Hardware Guide Appendix Calibration ToolINF7001a Hardware Guide Calibration Troubleshooting Tool INF7001a Hardware Guide 安全注意事項 JTouch 70顯示器I/O port 介紹前/後面板 RS232