HANNspree HF289 manual Special Notes on LCD Monitors

Page 6

SPECIAL NOTES ON LCD MONITORS

The following symptoms are normal with LCD monitor and do not indicate a problem.

Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears.

You may find slightly uneven brightness on the screen depending on the desktop pattern you use.

The LCD screen has effective pixels of 99.99% or more. It may include blemishes of 0.01% or less such as a missing pixel or a pixel lit all of the time.

Due to the nature of the LCD screen, an afterimage of the previous screen may remain after switching the image, when the same image is displayed for hours. In this case, the screen is recovered slowly by changing the image or turning off the Power Switch for hours.

If the screen suddenly flashes erratically or the backlighting fails, please contact your dealer or service center for repair. Do not attempt to repair the monitor yourself.

Lamp Disposal

LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS. FOR MORE INFORMATION, CONTACT THE ELECTRONIC INDUSTRIES ALLIANCE AT WWW.EIAE.ORG. FOR LAMP SPECIFIC DISPOSAL INFORMATION CHECK TTTTWWW.LAMPRECYCLE.ORG.

6

Image 6
Contents HF289 LCD Monitor FCC Class B Radio Frequency Interference Statement CanadaRecycling Information Table of Contents Safety Notice PrecautionsSpecial Notes on LCD Monitors Preface Features Checking the Contents of the PackageBefore Operating the Monitor Installation Instructions PowerInstall Remove Connecting to a PC Making ConnectionsConnecting to a A/V Device Adjusting the Viewing Angle Operating Instructions General InstructionsControl Panel Buttons Front Panel Control Menu / ReturnHOW to Adjust a Settings BRIGHTNESS/CONTRAST Brightness ContrastVGA/DVI Mode YPbPr/HDMI Mode Zoom Mode Page Near Timing Mode Plug & Play DDC2B Feature Plug and PlayTechnical Support FAQ For General ProblemsPage Cable not Connected Error Message & Possible SolutionsMode Resolution Input not SupportSpecifications Appendix