Preparing new discs with rough spots
A new disc may have rough edges on its inside and outside edges. If a disc with rough edges is used, the disc will not be properly seated and the player will not play the disc. Therefore, remove the rough edges in advance by using a ballpoint pen or pencil as shown on the right. Press the side of the pen or pencil against the inside and outside edges of the disc.
Installation
Notes:
-Choose a mounting location where the unit will not distract the driver.
-Before the installation of the unit, connect the wiring temporarily and make sure it is all connected properly and the unit and the system works.
-Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
-Consult with your dealer if installation requires the drilling of holes or other modifications of the vehicle.
-Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
-If installation angle exceeds 30° from horizontal, the unit may not perform properly.
-Avoid installing the unit where it will be subject to high temperature, such as from direct sunlight, or from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibration.
DIN mounting options
This unit can be installed either from the ‘Front’ (conventional DIN
Remove transit screws before installation
Before installing the unit, please remove the two transit screws.
User’s Manual - page 3