Radio Operation

Setting the station

There are a number of ways to set the sta- tion.

Automatic station search

➮Press the or button 7.

The next station that can be received is tuned in.

Manual station tuning

You can also tune to the station manually:

➮Press the or button 7.

Setting station search sensitivity

You can choose whether to search only for stations with strong signals, or whether weak stations should be included:

➮Select the waveband (AM or FM) to which the setting should apply.

➮Press the MENU button, 8.

➮Press the or button 7until “FM- SENS” or “AM-SENS” appears in the display.

➮Press the button or 7.

The current sensitivity value is shown on the display. “SENS 6” indicates the maximum sensitivity for the reception of distant trans- mitters, and “SENS 1” indicates the lowest sensitivity.

➮Set the desired sensitivity by pressing or 7.

➮Press the OK button 5or the MENU button 8to leave the menu. The set- tings are then saved.

Saving a station

Saving a station manually

➮Choose the desired memory level: FM I, FM II, FMT, M or MT.

➮Tune in the desired station as described under “Setting the station”.

➮Hold down the softkey 4 indicating the position [(“ST1” - “ST6”) where the sta- tion is to be stored] for longer than two seconds.

Saving a station automatically (Travelstore)

You can also save the six strongest stations in the area automatically. This is done in the FMT and MT memory levels.

Note:

Any stations previously saved on this level will be deleted.

To use the Travelstore function:

➮Press the TUNE button > when the ra- dio is operating.

The radio function menu is shown on the dis- play.

➮Press the softkey 4indicating “TS”.

Storing starts. “T-STORE” appears in the dis- play. When the procedure is complete, the station in memory location 1 on the FMT or MT level is played.

Going to a pre-set station

➮Select the memory level or waveband.

➮Press the softkey 4 indicating “ST1” - “ST6” for the desired station.