KeyCard theft-protection system

Installation/Connection

If you would like to install this equipment yourself or add any new components, please read the enclosed installation and connec- tion instructions carefully.

Do not connect the loudspeaker outputs to ground!

Use only the accessory and replacement parts approved by Blaupunkt.

This car radio is supplied with one KeyCard as standard.

However, the unit can also be operated with a second card.

If you have lost or damaged your KeyCard, you can buy a new one from your specialised dealer.

When using two KeyCards, you can indivi- dually store the following functions:

Bass, treble, balance and fader settings, assignments of preset buttons, Loudness, TA (traffic announcement volume), BEEP volume.

In addition to this, the settings activated be- fore switching the radio off, such as the waveband, station, TA priority, Loudness, AF, REG ON/OFF and seek tuning sensitivi- ty, will also remained stored.

This ensures that the basic settings you have programmed will automatically be activated as soon as you have inserted your KeyCard.

Putting the unit into operation

•Turn on the set and introduce the Key- Card into the slot with the contact area showing up (KeyCard tongue pulled out).

The car radio is now ready for operation.

If a wrong KeyCard is inserted, then “CARD ERR” will appear in the display. In this case please do not go on operating the set.

After approximately 10 seconds, the display will show “TURN OFF”. Now turn off the set. When inserting a card of a different kind (like for example a phone or credit card), the display will show “WRONG KC” for approxi- mately 2 seconds.

Remove the wrong card and turn off the set. Do not make further adjustments until you have a correct KeyCard available.

Removing the KeyCard

Never pull out the KeyCard directly.

•First press the KeyCard in.

This releases the card and puts it in the proper position for being removed.

•Now you can pull it out.

“Defining” a second KeyCard/ Replacing a KeyCard

While operating the unit with the first Key- Card, you can “define” a second one to be also used with the set:

•Insert the first KeyCard and turn on the set.

•Press the DSC button and select “LEARN KC” with /.

The display will switch to “CHANGE”.