
SWITCHING ON/OFF | ADJUSTING THE VOLUME |
Switching on by inserting a CD
If the device is switched off and there is no CD present in the drive,
➮press the button 2.
The
➮Gently insert the CD with its printed side uppermost into the drive until you feel some resistance.
The drive draws in the CD automatical- ly.
You must not hinder or assist the drive as it draws in the CD.
➮Gently close the control panel whilst exerting a little pressure until you feel it click into place.
The device switches on and starts play- ing the CD.
Note:
●If the ignition was switched off be- fore you inserted the CD, you will
first have to switch on the device by pressing button 1 in order to start playing the CD.
Adjusting the volume
You can adjust the volume in steps from 0 (off) to 66 (maximum).
To increase the volume,
➮turn the volume control 5 clock- wise.
To decrease the volume,
➮turn the volume control 5 anti- clockwise.
Setting the power-on volume
You can set the device’s default power- on volume.
➮Press the MENU button 9.
➮Press the or
button 7 repeat- edly until “ON VOLUME” appears in the display.
➮Adjust the
the buttons 7.
To help you adjust the setting more eas- ily, the device will increase or decrease the volume as you make your changes.
If you change the setting to “LAST VOL”, the volume when the device switches on will be the same as the volume level that was set the last time you switched the device off.
Note:
●To protect your hearing, the power- on volume is limited to a value of “38”. If the volume level was higher than this when the device was last switched off and the “LAST VOL” setting is activated, the system will reset the volume to “38” when you switch the device on again.
40