JVC GET0137-001A Adjusting the sound, Adjust the setting, Select the item you want to adjust

Adjusting the sound 2 Adjust the setting.

ENGLISH

You can adjust the sound characteristics to your preference.

1 Select the item you want to adjust.

Each time you press the

button, the adjustable items

change as follows:

To increase the level or turn on the loudness

To decrease the level or

turn off the loudness

Equalization pattern changes as you adjust the bass or treble.

		BAS	TRE				FAD
		(bass)	(treble)				(fader)
		VOL	LOUD				BAL
	(volume)		(loudness)			(balance)
Indication		To do:			Range
BAS*1		Adjust the bass.		–06 (min.)
				+06 (max.)
TRE*1		Adjust the treble.		–06 (min.)
				+06 (max.)
FAD*2		Adjust the front		R06 (Rear only)
		and rear speaker
		balance.		F06 (Front only)
BAL		Adjust the left		L06 (Left only)
		and right speaker
		balance.		R06 (Right only)
LOUD*1		Boost low and high
		frequencies to		LOUD ON
		produce a well-
		balanced sound		LOUD OFF
		at low volume
		level.
VOL*3		Adjust the volume.		00	(min.)
				50	(max.)

*1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including “USER.”

*2 If you are using a two-speaker system, set the fader level to “00.”

*3 Normally the control dial works as the volume control. So you do not have to select “VOL” to adjust the volume level.

Ex. 1: When you adjust “TRE” (treble)

Ex. 2: When you turn on the loudness

3 Repeat steps 1 and 2 to adjust the other items.

To reset each sound mode to the factory

settings, repeat the same procedure and

reassign the preset values listed in the table on page 21.

22