JVC GET0471-001A manual Indonesia, Daftar bagian-bagian untuk pemasangan dan penyambungan

Page 57

KD-SV3305

Installation/Connection Manual

Manual Pemasangan/Penyambungan

GET0471-008A

[UN]

ENGLISH

0207DTSMDTJEIN

EN, IN

© 2007 Victor Company of Japan, Limited

INDONESIA

This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.

Alat penerima ini didisain untuk beroperasi hanya pada 12 V DC, sistem listrik tanah NEGATIVE. Jika kendaraan anda tidak memiliki sistem ini, sebuah pembalik tegangan diperlukan, yang mana dapat dibeli di penyalur-penyalur audio mobil JVC.

WARNINGS

DO NOT install any unit in locations where;

it may obstruct the steering wheel and gearshift lever operations.

it may obstruct the operation of safety devices such as air bags.

it may obstruct visibility.

DO NOT operate the unit while driving.

If you need to operate the unit while driving, be sure to look ahead carefully.

The driver must not watch the monitor while driving.

If the parking brake is not engaged, “PARKING” flashes on the display, and no playback picture will be shown on the monitor.

This warning appears only when the parking brake wire is connected to the parking brake system built in the car.

To prevent short circuits, we recommend that you disconnect the battery’s negative terminal and make all electrical connections before installing the unit.

• Be sure to ground this unit to the car’s chassis again after installation.

Notes:

Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio dealer.

It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 to 8 ). If the maximum power is less than

50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 16 of the

INSTRUCTIONS).

To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.

The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.

Heat sink

Pendingin

PERINGATAN

JANGAN memasang unit pada tempat-tempat dimana;

ini dapat menghalangi pengoperasian roda kemudi dan tuas gigi persneling

ini dapat menghalangi pengoperasian alat pengaman seperti kantung udara.

ini dapat menghalangi pandangan.

JANGAN mengoperasikan unit sewaktu mengemudi.

Jika Anda harus mengoperasikan unit sewaktu mengemudi, pastikan Anda melihat ke depan dengan hati-hati.

Pengemudi tidak boleh menonton monitor selagi mengemudi.

Jika rem parkir tidak sedang dipakai, “PARKING” berkedip pada display, dan tidak ada gambar permainan-ulang yang akan dipertunjukkan pada monitor.

Peringatan ini muncul hanya jika kabel rem parkir telah tersambung ke sistem rem parkir yang terpasang tetap di dalam mobil.

Untuk mencegah hubungan pendek, kami menyarankan anda memutuskan sambungan terminal negatif baterai dan membuat semua sambungan-sambungan listrik sebelum memasang alat penerima.

• Pastikan untuk mentanahkan alat penerima ini ke casis mobil kembali setelah pemasangan.

Catatan:

Ganti sekring dengan voltase yang sudah ditetapkan. Jika sekring sering meledak, konsultasikan pada penyalur audio mobil JVC anda.

Disarankan untuk menghubungkan speaker-speaker dengan maksimum power lebih dari 50 W (keduanya di belakang dan di depan, dengan sebuah impedansi 4 sampai 8 ). Jika maksimum power kurang dari 50 W, ganti pengaturan “AMP GAIN” (“PENAMBAH PENGUAT”) untuk mencegah speaker-speaker dari kerusakan (lihat halaman 16 dari BUKU PETUNJUK).

Untuk mencegah hubungan pendek, tutup ujung-ujung terminal-terminal yang TIDAK DIGUNAKAN dengan pita isolasi.

Pendingin menjadi sangat panas setelah digunakan. Hati-hati untuk tidak menyentuhnya ketika memindahkan alat penerima ini.

PRECAUTIONS on power supply and speaker connections:

DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged.

BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.

TINDAKAN-TINDAKAN PENCEGAHAN pada suplai power dan sambungan-sambungan speaker:

JANGAN sambungkan ujung-ujung speaker dari kabel power ke baterai mobil; sebaliknya, alat penerima tersebut akan secara serius rusak.

SEBELUM menyambung ujung-ujung speaker dari kabel power ke speaker-speaker, cek perkabelan speaker dalam mobil anda.

Parts list for installation and connection

Daftar bagian-bagian untuk pemasangan dan penyambungan

If any item is missing, consult your JVC car audio dealer immediately.

Jika ada item yang hilang, segera hubungi dealer audio mobil JVC anda.

A / B

C

D

E

Hard case/Control panel

Sleeve

Trim plate

Power cord

Kotak keras/Panel kontrol

Selongsong

Plat rapi

Kabel power

F

G

H

I

Crimp connector

Washer (ø5)

Lock nut (M5)

Mounting bolt (M5 20 mm)

Konektor kerut

Perapat sambungan (ø5)

Mur kunci (M5)

Baut bingkai (M5 20 mm)

J

K

L

M

Rubber cushion

Handles

Remote controller

Battery

Bantalan karet

Pegangan-pegangan

Remote kontrol

Baterai

1

Image 57
Contents Instructions How to reset your unit How to forcibly eject a discDriver must not watch the monitor while driving Contents Control panel Parts identificationDisplay window Installing the lithium coin battery CR2025 Main elements and featuresVOL. + / buttons Operations 5UP / Down ∞buttons Changes the preset stationsSelects a track/file directly Number button 1 7 6 EQ equalizer buttonBasic operations ~ Turn on the power Basic settingsFor FM/AM tuner ⁄ Adjust the volume @ Adjust the sound as you want. SeeRadio operations When an FM stereo broadcast is hard to receiveStoring stations in memory Start searching for a stationListening to a preset station Manual presettingDisc operations Playing a disc in the unitSelect a disc Playing discs in the CD changerAbout MP3 and WMA discs About the CD changerOn-Screen OSD information Selecting the audio channelTo correct a mis-entry and to return to the previous menu To select a folder To select a track Selecting the playback modesMP3/WMA control screen operations Prohibiting disc ejection Other main functionsAdjusting the sound Sound adjustmentsIndication For Indication RangeGeneral settings PSM Indications Setting, referenceItems if necessary Items to adjust Regardless of the settingScrolls the track information once ScrollTo resume playback, press 4 after pressing Mode Adjust the volume ⁄ Adjust the sound as you want. SeeTo pause*1 or stop*2 playback PreparationsSelecting a track from the menu Select your desired playback mode Repeat playSelect the desired menu For iPod For D. playerHow to handle discs MaintenanceHow to clean the connectors Moisture condensationTo keep discs clean More about this unitTo play new discs Playing a CD-R or CD-RW GeneralPlaying a VCD disc Playing an MP3/WMA discChanging the source General settings-PSMEjecting a disc MP3 files encoded with LayerTroubleshooting Symptoms Remedies/CausesDisc Reset button of the CD changer Album name Limited number of symbolsDisplay Charge the battery Playback stops Connecting an iPod nanoSpecifications FM TunerAM Tuner Having Trouble with operation? Parts list for installation and connection Precautions on power supply and speaker connectionsRemoving the unit Installation IN-DASH MountingConnecting the parking brake wire / µËÕ ¬‡√¡Õ Connecting the crimp connector / «‘∏’µËÕ¢«µËÕÈ- À√Àπ’Typical connections / √‡ËÕ¡µËÕ·ªµ KV-MR9010 Connecting the monitor / √µËÕÕ¿æInstructions Buku Petunjuk Be careful not to drop the disc when it ejects Operations Maintenance Control panel Skips 10 items at a time if pressed and held Selects the audio channel for VCD playback Basic operations Radio operations Before performing any operations, make sure Playing discs in the CD changer On-Screen OSD information Selecting the playback modes For WMA disc Adjust the front and rear speaker balance. R06 to F06 General settings PSM Scroll *1 Once IPod/D. player operations Selecting the playback modes Clock Ôext in or Line Sticker residue General If you change the AMP Gain setting from Troubleshooting Have intended them to play Tone Control Range Ada Masalah dengan cara Pengoperasian? Daftar bagian-bagian untuk pemasangan dan penyambungan IndonesiaMemindahkan alat penerima Pemasangan BINGKAI-DALAM DashTypical connections / Ciri khas sambungan-sambungan Connecting the crimp connector / Menyambung konektor kerutPenguat JVC Connecting the monitor / Menyambung monitor