3.1.10Removing the connector board (See Figs.13 to 15)
•Remove the panel assembly, side heat sink, top chassis as- sembly and front bracket assembly.
(1)From the front side of the front bracket assembly, remove the two screws M. (See Fig.13.)
(2)Remove the joints b and remove the detach lever from the front bracket assembly. (See Fig.13.)
Reference:
When attaching the detach lever, insert the end of the torsion spring in the hole c of the front bracket assembly. (See Fig.13.)
(3)From the back side of the front bracket assembly, remove the screw N attaching the connector cover. (See Fig.14.)
(4)Remove the connector cover in the direction of the arrow while releasing the tabs d in an upward direction. (See Fig.14.)
(5)Remove the reinforce plate and take out the connector board from the front bracket assembly. (See Fig.15.)
Front bracket assembly M | Torsion spring | ||||
| b | ||||
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| c |
Detach lever | b |
Fig.13 |
|
Connector cover | d |
d |
N
Fig.14
Connector board
Reinforce plate
Front bracket assembly
Fig.15