3.2.4Removing the clamper unit (See Fig.5 to 7)
•Remove the top cover and the mechanism section.
(1)Remove the clamper2 spring on the bottom of the mecha- nism section. (See Figs.5.and 6.)
(2)Release the part d of the clamper spring from the bending part of the chassis base assembly. (See Fig.7.)
(3)Move the clamper unit in the direction of the arrow and turn. Release the two joints e and f, then remove the clamper unit upward. (See Fig.6.)
3.2.5 Reattaching the clamper unit (See Fig.5 to 9)
(1)Attach the clamper spring to the clamper unit. (See Fig.8.)
(2)Move the clamper unit to set the side joints e and f to each boss of the chassis base assembly. Make sure that part g is inserted to the notch of the chassis base assembly. (See Figs.5 and 9.)
(3)Move the part d of the clamper spring to the outside of the bending part of the chassis base assembly. (See Fig.7.)
(4)Attach the clamper2 spring to the chassis base assembly. (See Figs.5 and 6.)
Caution:
When reattaching, temporarily hook the end of the clamper spring as shown in the figure to make the work easy. (See Fig.8.)
Clamper unit
g
Clamper spring
f
e
Clamper2 spring
Chassis base assembly
Fig.5
Clamper2 spring
Chassis base assembly
Fig.6
Clamper spring
d
Chassis base assembly
Fig.7