JVC KD-AVX1 Preventing static electricity, Grounding to prevent damage by static electricity

1.2Preventing static electricity

Electrostatic discharge (ESD), which occurs when static electricity stored in the body, fabric, etc. is discharged, can destroy the laser diode in the traverse unit (optical pickup). Take care to prevent this when performing repairs.

1.2.1Grounding to prevent damage by static electricity

Static electricity in the work area can destroy the optical pickup (laser diode) in devices such as CD players. Be careful to use proper grounding in the area where repairs are being performed.

(1)Ground the workbench

Ground the workbench by laying conductive material (such as a conductive sheet) or an iron plate over it before placing the traverse unit (optical pickup) on it.

(2)Ground yourself

Use an anti-static wrist strap to release any static electricity built up in your body.

(caption)

Anti-static wrist strap

1M

Conductive material (conductive sheet) or iron plate

(3)Handling the optical pickup

•In order to maintain quality during transport and before installation, both sides of the laser diode on the replacement optical pickup are shorted. After replacement, return the shorted parts to their original condition.

(Refer to the text.)

•Do not use a tester to check the condition of the laser diode in the optical pickup. The tester's internal power source can easily destroy the laser diode.

1.3Handling the traverse unit (optical pickup)

(1)Before disconnecting the flexible wire from the connector CN101 on the mechanism control board, solder the short-circuit points on the flexible wire.

Caution:

If you do not follow this instruction, the DVD pickup may be damaged.

(2)Disconnect the flexible wire from the connector CN101 on the mechanism control board.

(3)Remove the solders from the short-circuit points on the flexible wire after replacing the DVD pickup.

(4)Connect the flexible wire to the connector CN101 on the mechanism control board.

Flexible wire

CN101

Short-circuit points

Mechanism control board

1-6 (No.MA165)