ENGLISH
Assigning names to the sources | 4 Select a character. |
| • About the available |
You can assign names to discs (both in this unit | characters, see page 37. |
and in the CD changer), station frequencies and |
|
the external component. |
|
After assigning a name, it will appear on the display |
|
when you select the source. |
|
Sources | Maximum number of |
| characters |
|
|
CDs* | up to 32 characters |
| (up to 40 discs) |
|
|
Station frequencies | up to 10 characters |
|
|
External component | up to 8 characters |
|
|
*You cannot assign a name to a CD Text.
1 Select a source you want to assign a name to.
When you select a
source, the power
automatically comes on.
5 Move the cursor to the next
(or previous) character position.
6 Repeat steps 3 to 5 until you finish entering the name.
7
2 Press and hold SEL (select) for more than 2 seconds while pressing DISP (D).
Ex.: When you select CD as the source
3 Select the character set you want while the first character position is flashing.
Each time you press the button, the character set changes as follows:
A – Z |
| a – z |
(capital) |
| (small) |
1 – 0 & Symbols
To erase the entered characters
Insert spaces using the same procedure
described above.
Notes:
•When you try to assign a name to the 41st disc,
“Name Full” appears on the display. (In this case, delete unwanted names before assignment.)
•When the CD changer is connected, you can assign names to discs in the CD changer. These names can also be shown on the display if you insert the discs in this unit.
28
(numbers)