Alpine TDM-7582E owner manual Basic Operation, Detaching the Front Panel, Initial System Start-Up

Detaching the Front Panel

1 Press the POWER button to turn off the power.

2 Press the (Release) button until the front panel pops out.

3 Grasp the left side of the front panel and pull it out.

NOTES

•The front panel may become hot (especially the connector terminals). This is not a malfunction.

•To protect the front panel, place it in the supplied carrying case.

Initial System Start-Up

1 Immediately after installing or applying power to the unit, it should be initialized. To do this, first, remove the detachable front panel. Behind the front panel, to the right of the connector, there is a small hole. Using a pencil or other pointed object, press the red Reset switch mounted behind this hole to complete the initialization procedure.

Reset switch

Attaching the Front Panel

1 First, insert the right side of the front panel into the main unit. Align the 2 small holes on the front panel with the 2 projections on the main unit.

2 Push the left side of the front panel until it locks firmly into the main unit.

NOTE

Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.

Automatic Setup (A.S.U.)

This convenient feature sets up the unit automatically after installation.

1 Press the POWER button to turn on the unit.

NOTE

When Power is turned on for the very first time, the A.S.U. (Automatic Set-Up) function will be initiated automatically. See A.S.U. description below.