JVC KD-R426, KD-R526 manual Preparing the remote controller, About discs, Discs that cannot be used

Page 5

Preparing the remote controller

When you use the remote controller for the first time, pull out the insulation sheet.

Insulation sheet

If the effectiveness of the remote controller decreases, replace the battery.

Replacing the lithium coin battery

CR2025

KD-R526 is equipped with the steering wheel remote control function.

For details, refer also to the instructions supplied with the remote adapter.

Caution:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

Battery shall not be exposed to excessive heat such as sunshine, fire, or the like.

Warning (to prevent accidents and damage):

Do not install any battery other than CR2025 or its equivalent.

Do not leave the remote controller in a place (such as dashboards) exposed to direct sunlight for a long time.

Store the battery in a place where children cannot reach.

Do not recharge, short, disassemble, heat the battery, or dispose of it in a fire.

Do not leave the battery with other metallic materials.

Do not poke the battery with tweezers or similar tools.

Wrap the battery with tape and insulate when throwing away or saving it.

About discs

This unit can only play the CDs with:

Discs that cannot be used:

Discs that are not round.

Discs with coloring on the recording surface or discs that are dirty.

You cannot play a Recordable/ReWritable disc that has not been finalized. (For the finalization process refer to your disc writing software, and your disc recorder instruction manual.)

3-inch CD cannot be used. Attempt to insert using an adapter can cause malfunction.

Handling discs:

Do not touch the recording surface of the disc.

Do not stick tape etc. on the disc, or use a disc with tape stuck on it.

Do not use any accessories for the disc.

Clean from the center of the disc and move outward.

Clean the disc with a dry silicon or soft cloth. Do not use any solvents.

When removing discs from this unit, pull them out horizontally.

Remove the rims from the center hole and disc edge before inserting a disc.

ENGLISH

5

Image 5
Contents KD-R526/KD-R426 European Union only Stop the car before operating the unit Thank you for purchasing a JVC productTo obtain the best possible performance from the unit Contents Setting the clock Canceling the display demonstrationInitial setting Initial settingAbout discs Preparing the remote controllerDiscs that cannot be used Handling discsBasic operations Automatic presetting FM Improving the FM reception Manual presetting FM/AMSelecting a preset station Listening to the radioStopping playback and ejecting the disc Listening to a discBasic operations Selecting a track/folder from the listSetting Name Connecting the other external componentsListening to the other external components Preparation~ Ÿ Listening to a USB deviceSelecting a track from the menu Listening to an iPod/iPhoneSelecting the control terminal Album RND is not available for some iPod/ iPhone Selecting a preset sound modeIpod Mode / EXT Mode are not available Menu operations Storing your own sound modeFader *7, *8 Intervals. / OFF CancelsLevel. / OFF Cancels KS-BTA100. / OFF Cancels 00 08 04 Adjusts the subwoofer output levelDisplayed only when the source is FM. For settings, see On / OFF Activates or deactivates the keypress toneTroubleshooting Noise is generated Skip to another file For KD-R526Order you have intended Unit. / Reattach the USB device againAdjusting the microphone volume Using Bluetooth devicesAbout microphone volume Receiving a callSpecifications Having Trouble with operation? This unit does not work at all. Have you reset your unit? Precautions on power supply and speaker connectionsIn-dash mounting / 裝設、固定在儀表板內 Removing the unit / 拆卸本機KD-R426 Vehicle-specific Wiring Harness Separately purchasedKD-R526