ENGLISH
Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.
Ex: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band.
1 Select the band (FM1 – 3, AM) you want to store FM stations into (in this example, FM1).
•Each time you press the button, the FM band changes as follows:
FM 
FM1
FM2
FM3 
AM 
AM
2 Tune in to a station of 88.3 MHz.
Press 
¢ to tune stations of higher frequencies.
Notes:
•A previously preset station is erased when a new station is stored in the same preset number.
•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.
Tuning in to a preset station
You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on page 9 and 10.
1 Select the band (FM1 – 3, AM).
FM 
FM1
FM2
FM3 
AM 
AM
Press 4
to tune 
stations of lower frequencies.
3 Press and hold the number button (in this example, 1) for more than 2 seconds.
“P1” flashes for a few seconds.
4 Repeat the above procedure to store other stations into other preset numbers.
2 Select the number (1 – 6) for the preset station you want.
7 | 8 MO | 9 | 10 | 11 RPT | 12 RND |
10