JVC KD-SH707 manual To turn the line input switch on or off, Cut Off F, Area

To select the subwoofer cutoff frequency

– CUT OFF F

When a subwoofer is connected to this unit, select an appropriate cutoff frequency level for your subwoofer.

When shipped from the factory, the subwoofer cutoff frequency is set to “MID(80Hz).”

• LOW(50Hz): Frequencies higher than 50 Hz are cut off to the subwoofer.

• MID(80Hz): Frequencies higher than 80 Hz are cut off to the subwoofer.

•HIGH(115Hz): Frequencies higher than 115 Hz are cut off to the subwoofer.

To change the AM/FM channel intervals

– AREA

When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and 200 kHz for FM (AREA US settings).

You will have to change the channel intervals when using this unit in an area other than North America and South America.

•AREA EU: Select this when using this unit in an area other than North and South America. (9 kHz for AM and 50 kHz (for manual tuning) / 100 kHz (for searching) for FM)

•AREA US: Select this when using this unit in North or South America. (10 kHz

for AM and 200 kHz for FM)

Note:

If the channel intervals settings are changed, the names assigned to the stations will be erased from memory. To reassign the names, see “Assigning names to the sources” on page 35.

To select the external component to use

–EXT IN (For KD-SH707 only)

You can connect the external component to the CD changer jack on the rear using the Line Input Adaptor KS-U57 (not supplied).

To use the external component as the playback source through this unit, you need to select which component — CD changer or external component — to use.

When shipped from the factory, “CD CHANGER” is selected as the external component.

•CD CHANGER: To use the CD changer.

•LINE INPUT: To use the external component other than CD changer.

Note:

For connecting the Line Input Adaptor KS-U57 and the external component, refer to the Installation/ Connection Manual (separate volume).

To turn the line input switch on or off

– LINE IN (For KD-SH909 only)

You can switch the line input off when no external component is connected to the LINE IN plugs. When shipped from the factory, the line input switch is set to “ON.”

•	ON:	You can select “LINE INPUT
		(LINE)” as the playback source.
•	OFF:	You cannot select “LINE INPUT
		(LINE)” as the playback source.

ENGLISH

33