JVC KD-SH707 manual To erase the input characters, Select a source you want to assign a name to

Repeat steps 3 to 5 until you finish inputting the name.

Assigning names to the sources

You can assign names to stations, CDs, and the external components.

After assigning a name, it will appear on the display when you select the source.

Sources	Maximum number of
	characters
Station frequencies	up to 11 characters (up to
	30 station frequencies
	including both FM and AM)
CDs*	up to 32 characters
	(up to 40 discs)

External components up to 11 characters

*You cannot assign a name to a CD Text or an MP3 disc.

1 Select a source you want to assign a name to.

Each time you press the

button, the source changes as described on page 8.

2 Press and hold SEL (select) for more than 2 seconds while pressing DISP (D).

D

DISP

3 Select the character set you want while

“” is flashing.

DEach time you press the button,

DISPthe character set changes as follows:

Capital letters ( ) Small letters ( )

Numbers and symbols ( )

4 Select a character.

About the available

characters, see page 43.

5 Move the cursor to the next

(or previous) character position.

6

7 Finish the procedure while the last selected character is flashing.

ENGLISH

DISC

Ex.: When you select “CD” as the source

To erase the input characters

Insert spaces using the same procedure described above.

Notes:

•When you try to assign a name to the 41st disc, “NAME FULL” appears on the display. (In this case, delete unwanted names before assignment.)

•When the CD changer is connected, you can assign names to discs in the CD changer. These names can also be shown on the display if you insert the discs in this unit.

35