JVC KD-SH99 manual Tuning into a preset station, Manual preset, Tune into a station of 88.3 MHz

ENGLISH

Manual preset

You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.

Ex.: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band

1 Select the band (FM1 – 3, AM) you want to store stations into (in this example, FM1).

1 Press SOURCE repeatedly to select the tuner as the source.

2If necessary, press BAND (B) repeatedly to

select FM 1.

Each time you press the button, the band changes as follows:

FM 1FM 2FM 3 AM

2 Tune into a station of 88.3 MHz.

Press ¢ to tune into stations of higher frequencies.

Press 4 to tune into stations of lower frequencies.

Tuning into a preset station

You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on page 9.

1 Select the band (FM1 – 3, AM).

1 Press SOURCE repeatedly to select the tuner as the source.

2If necessary, press BAND (B) repeatedly to select FM or AM.

Each time you press the button, the band changes as follows:

FM 1FM 2FM 3 AM

2 Select the number (1 – 6) for the preset station you want.

3 Press and hold the number button (in this example, 1) for more than 2 seconds.

“P1” flashes for a while.

4 Repeat the above procedure to store other stations into other preset numbers.

Notes:

• A previously preset station is erased when a new station is stored in the same preset number.

• Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations

If the sound quality decreases and the stereo effect is lost while listening to an FM station...

In some areas, adjacent stations may interfere with each other. If this interference occurs, this unit can automatically reduce this interference noise (the initial setting when shipped from the factory). However, in this case, the sound quality will be degraded and the stereo effect will be also lost.

If you do not want to degrade the sound quality and to lose the stereo effect, rather than to eliminate the interference noise, see “To change the FM tuner selectivity – IF FILTER” on page 27.

When using this until in an area other than North or South America:

You need to change the AM/FM channel intervals. See “To change the AM/FM channel intervals – AREA” on pages 26 and 27.

10

again.