Appendix C: Important Safety and Handling Instructions
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could use the authority to operate this equipment if an unauthorized change or modification is made.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna
•Increase the separation between the equipment and the receiver
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•Consult the dealer or an experienced radio/TV technician for help.
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS
Installation Precautions
Mounting location precautions to ensure and observe:
1.The unit is not subject to direct sunlight.
2.The unit is not near heat sources (such as heaters).
3.The unit is not exposed to rain or moisture.
4.The unit is not exposed to excessive dust, sand or dirt.
5.The unit is not subject to excessive vibration.
6.The fuel tank should not be damaged during installation.
7.There should be no wire harnesses or pipes under the place where you are going to install the unit.
8.The spare tire, tools or other equipment in or under the trunk should not be interfered with or damaged.
9.Make holes only after making sure there is nothing on the other side of the mounting surface.
Page 51
PhatNoise Car Audio System User Manual