Note:
After selecting a range, the station last selected in this range will be heard.
When the monitor is open, the “BAND” button 
on the screen is also available for the selection of the wavelength range.
14.3Searching for a radio station with the scanner
To set the stations, select the desired wave band with the “BAND” button 
(section 13.2). In order to begin searching in the desired direction, briefly press the 
. Press the button towards the left to diminish the search frequency or to the right to increase the search frequency. The scanner will stop at the next available station.
When the monitor is open, the buttons 
and 
on the
14.4 Manual search for a radio station
In order to select a station manually, press the 
for about three seconds towards the right or left. The display will indicate “MANUAL”. Now press the 
towards the right to increase the frequency, or to the left to diminish the frequency until the desired frequency is indicated on the display. The frequency will change in 50kHz increments in the FM range. If there is no entry for about seven seconds, the device will switch back to automatic station search. The display will indicate “AUTO”.
When the monitor is open, the buttons 
and 
on the 
and 
for three seconds. MANUAL will be indicated in the corresponding field. If there is no entry for about seven seconds, the device will switch back to automatic station search. The corresponding field on the screen will indicate “AUTO” again.
37