Adjusting sound
You can select the following modes for adjusting sound depending on the music you listen to: BASS (low frequencies), TRE (high frequencies), BAL (left/right), FAD (front/rear) and
1Press SEL repeatedly to select the mode to be adjusted.
Pressing SEL cycles through the modes. The selected mode’s indicator flashes (except for H- BASS).
2Turn the Smart Jog to increase or decrease the level for the selected mode (except for
In
Note
Adjust the level or select on/off within 5 seconds, or the selected mode will return to previous state.
Aligning the source levels
(Source Level Adjuster)
Volume may vary each time you change the source mode. In this case, you can align each source mode’s volume to almost the same level.
1Press FNC repeatedly to select the desired mode.
2Press DISP while pressing SEL. “LA 0” appears in the display.
3Turn the Smart Jog to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode will be canceled.
Restoring the factory settings
1Turn off the unit.
2Press and hold DISP until “LA
Note
You can restore the factory settings only for VOL, BASS, TRE, BAL, FAD, and
Muting button beep sounds
1Turn off the unit.
2Press and hold SEL until “BEEP” appears in the display.
3Turn the Smart Jog to select on (level indicators appear) or off (level indicators disappear).
4Press and hold SEL until the unit turns off.
Setting the clock
1Press DISP to have the clock displayed.
If the clock indication is already displayed, skip this step.
2Press and hold DISP until the clock indication flashes in the display.
3Press TUNEi (to set hour) or TUNEk (to set minute) and turn the Smart Jog.
4Press DISP.
Displaying the clock
1Press DISP.
To return to the former display, press DISP again.
RADIO OPERATION
Tuning in to a station
(Seek/Manual Tuning)
Band indicator | Local indicator | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Stereo indicator Frequency indication
1Press FNC repeatedly to select the desired band (FM1, FM2, FM3, AM1 or AM2).
2Press TUNEi (to move to higher frequencies) or TUNEk(to move to lower frequencies) to tune in to a station.
“ST” appears in the display when an FM station is broadcasting in stereo, and receiving conditions are good.
Seek Tuning and Manual Tuning
•Press and hold TUNEi or TUNEk until Seek Tuning starts.
The unit locates a station automatically (Seek Tuning).
•Press TUNEior TUNEkrepeatedly to search for a desired station while increasing or decreasing the frequency step by step (Manual Tuning).
To stop Seek Tuning, press TUNEi or TUNEk
again.
3 ENGLISH