Basic Operation
SOURCE/
POWER |
|
|
| BAND |
| MODE/Rotary encoder | |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
g f MUTE F/SETUP
Detaching the Front Panel
1 Press and hold the SOURCE/POWER button for more than 3 seconds to turn off the power.
2 Press the 
(Release) button at lower left corner until the front panel pops out.
3 Grasp the left side of the front panel and pull it out.
NOTES
•The front panel may become hot in normal usage (especially the connector terminals), this is not malfunction.
•To protect the front panel, place it in the supplied carrying case.
Attaching the Front Panel
1 First, insert the right side of the front panel into the main unit. Align the 2 small holes on the front panel with the 2 projections on the main unit.
2 Push the left side of the front panel until it locks firmly into the main unit.
2 |
1 |
NOTE
Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.
Initial System Start-Up
Immediately after installing or applying power to the unit, it should be initialized. To do this, first, remove the detachable front panel. Behind the front panel, to the right of the connector, there is a small hole. Using a
1
RESET switch
Turning Power On and Off
1 Press the SOURCE/POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button except the eject c and DISP 
button.
The volume level gradually increases to the previous level you were listening to before the unit was turned off. Press and hold the SOURCE/POWER button for more than 3 seconds to turn off the unit.
NOTE
The very first time the power is turned on, the unit will be in the tuner mode at volume level 12, with BBE* and the LOUD** functions on.
*
**
Subwoofer On and Off
1 Press and hold the F/SETUP button for at least 3 seconds.
2 Press the g or f button to select the SUB ( Subwoofer) mode.
3 Press the BAND button to select Subwoofer ON or OFF.
4 After setting is completed, press the F/SETUP button to return to normal mode.
NOTES
•Initial mode is "Subwoofer ON."
•Set to "Subwoofer OFF" unless the subwoofer is used.
•When the subwoofer is turned on, the subwoofer output level can be adjusted. For more details, refer to the Adjusting Volume/Balance/Fader.