Alpine IVA-D901 owner manual General Setup Operation, 31-EN

Setting the Digital Output

To connect an audio processor using the optical digital output, set to “ON” by the following procedure.

Setting item: OPT.OUT

Setting contents: OFF / ON

•Afterwards, set ACC to OFF once, then turn it ON again. The setting of Digital Output is decided.

Setting the TV Screen Setting

Use the procedure described below to set the output screen according to the type of TV monitor (rear monitor) being used.

Setting item: TV SCREEN

Setting contents: 4:3 LB / 4:3 PS/ 16:9

•For some discs, the picture may not be set to the selected screen size. (For details, refer to the explanation on the disc’s jacket.)

4:3 LB:

Select this when connected to a conventional 4:3 size (normal TV aspect ratio) monitor. There may be black stripes visible at the top and bottom of the screen (when playing a 16 : 9 size movie). The width of these stripes will depend upon the original aspect ratio of the theatrical release of the movie.

GENERAL Setup

4

3

2

1

Rotary encoder V.SEL

SOURCE/POWER

General Setup Operation

5

6

7

4:3 PS:

Select this when connected to a conventional 4:3 size monitor. The picture will fill the entire TV screen. However, due to the mismatch in aspect ratio, parts of the movie at the extreme left and right sides will not be visible (when playing a

16 : 9 size movie).

To display the General mode screen:

To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.

1.Bring your vehicle to a complete stop at a safe location. Engage the parking brake.

2.Keep pushing the foot brake and release the parking brake once then engage it again.

3.When the parking brake is engaged for the second time, release the foot brake.

•For automatic transmission vehicles, place the transmission lever in the Park position.

Now, the locking system for the General mode operation has been released. Engaging the parking brake can reactivate the General mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3), of “To display the General mode screen.”

Each time the ignition is turned OFF, perform the procedure of “To display the General mode screen.”

The following steps 1 to 6 are common operations to each “Setting item” of GENERAL Setup. Refer to each section for

16:9:	details.
Select this when connected to a wide screen TV. This is	the
factory setting.	1 Press SOURCE/POWER.
	The main menu is displayed.
	2 Press 6 (SETUP).
	The Setup mode screen appears.
	3 Turn the Rotary encoder to select “GENERAL,”
	then press the Rotary encoder.
	The GENERAL list is displayed.

Continued

31-EN