Alpine IVA-D901 owner manual 72-EN

1Antenna Extension Cable

2Digital Output Terminal (Optical)

Use when combining fiber digital input compatible products.

3Remote Control Interface Connector Connect to the remote control interface box.

4Power Supply Connector

5DC/DC Converter

•Do not install the converter at a location subjected to water such as under the floor mat or air conditioner. This may cause a malfunction.

•Do not bundle the DC/DC converter cable with other audio cables. Doing so may induce noise into your system.

•Keep the DC/DC converter away from the Antenna cables and the rear side of the unit, otherwise noise may be generated when receiving radio broadcast.

6Battery Lead (Yellow)

Connect this lead to the positive (+) post of the vehicle's battery.

7Fuse Holder (10A)

8Ground Lead (Black)

Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.

9Remote Control Output Lead (White/Brown) Connect this lead to the remote control input lead. This lead outputs the controlling signals from the remote control.

!Remote Control Input Lead (White/Brown)

Connect the external Alpine product to the remote control output lead.

"Reverse Lead (Orange/White)

Use only when a back-up camera is connected. Connect to the plus side of the car's reverse lamp that lights when the transmission is shifted into reverse (R).

Switches the video picture to the back-up camera. This is linked with putting the car into reverse (R).

#Display Output Terminal

$ Remote IN/OUT Terminal

%Ai-NET Connector

Connect this to the output or input connector of other product (CD Changer, Equalizer, etc.) equipped with Ai- NET.

&Antenna Receptacle

( System Switch

When connecting an equalizer or divider using Ai-NET feature, place this switch in the EQ/DIV position. When no device is connected, leave the switch in the NORM position.

•Be sure turn the power off to the unit before changing the switch position.

) Remote Turn-On Lead (Blue/White)

Connect this lead to the remote turn-on lead of your amplifier or signal processor.

~Power Antenna Lead (Blue)

Connect this lead to the +B terminal of your power antenna, if applicable.

+Audio Interrupt In Lead (Pink/Black)

,Parking Brake Lead (Yellow/Blue)

Connect this lead to the power supply side of the parking brake switch to transmit the parking brake status signals to the IVA-D901.

-Foot Brake Lead (Yellow/Black)

Connect to the vehicle's foot brake lead or brake lamp lead.

. Switched Power Lead (Ignition) (Red)

Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides

(+) 12V only when the ignition is turned on or in the accessory position.

/Fuse Holder (10A)

:Right Front (+) Speaker Output Lead (Gray)

;Right Front (–) Speaker Output Lead (Gray/Black)

<Right Rear (–) Speaker Output Lead (Violet/Black)

=Right Rear (+) Speaker Output Lead (Violet)

>Left Rear (+) Speaker Output Lead (Green)

?Left Rear (–) Speaker Output Lead (Green/Black)

@Left Front (–) Speaker Output Lead (White/Black)

[ Left Front (+) Speaker Output Lead (White)

\Monitor Extension Cable (Included)

] Subwoofer output Terminal

Connect the input lead of an amplifier for the subwoofer to this terminal.

^Rear input/output Terminal

Use when connecting an amplifier or Equalizer.

_ Front input/output Terminal

Use when connecting an amplifier or Equalizer.

To prevent external noise from entering the audio system.

•Locate the unit and route the leads at least 10 cm away from the car's electrical harness.

•Keep the battery power leads as far away from other leads as possible.

•Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.

•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.

•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.