Alpine DVA-5205E owner manual Temperature

Page 4

Precautions

Temperature

Be sure the temperature inside the vehicle is between +60°C (+140°F) and –10°C (+14°F) before turning your unit on.

Moisture Condensation

You may notice the CD playback sound wavering due to condensation. If this happens, remove the disc from the player and wait about an hour for the moisture to evaporate.

Damaged Disc

Do not attempt to play cracked, warped, or damaged discs. Playing a bad disc could severely damage the playback mechanism.

Maintenance

If you have problems, do not attempt to repair the unit yourself. Return it to your Alpine dealer or the nearest Alpine Service Station for servicing.

Never Attempt the Following

Do not grip or pull out the disc while it is being pulled back into the player by the automatic reloading mechanism.

Do not attempt to insert a disc into the unit when the unit power is off.

Inserting Discs

Your player accepts only one disc at a time for playback. Do not attempt to load more than one disc.

Make sure the label side is facing up when you insert the disc. Your player will auto- matically eject any disc that is inserted incorrectly.

Playing a disc while driving on a very bumpy road may result in skips, but this will not scratch the disc or damage the player.

Irregular Shaped Discs

Make sure the discs you use in this unit do not have any irregularities. The outer and inner edges should be round and smooth. Use of irregularly shaped discs may cause damage to the mechanism.

New Discs

As a protective measure to prevent the CD from jamming, the CD player will automati- cally eject discs with irregular surfaces or inserted incorrectly. When a new disc is inserted into the player and ejected after initial loading, using your finger, feel around the inside of the centre hole and outside edge of the disc. If you feel any small bumps or irregularities, this could inhibit proper loading of the disc. To remove the bumps, rub the inside edge of the hole and outside edge of the disc with a ball-point pen or other such instrument, then insert the disc again.

Installation Location

Make sure the DVA-5205E will not be installed in a location subjected to:

•Direct sun and heat

•High humidity and water

•Excessive dust

•Excessive vibrations

4

Image 4

Contents DVA-5205E Precautions Precautions Temperature Contents About DVDs About DVDsCD-ROMs DVDsDiscs playable on this DVD player Discs playable on this DVD playerWhen using remote control When using remote controlReplacing the batteries Loading and unloading discs Loading and unloading discsLoading discs Unloading discsTurning the power on and off Turning the power on and offAdjusting the volume Switching between Ntsc and PAL configurationPress NTSC/PAL for at least 5 seconds Move the rotary encoder to the right or leftPlaying discs Playing discsPress If a menu screen appearsPlayback StoppingStopping playback Fast-forwarding/ DVD Video CD Fast-reversing During playbackPress c or f Press to return to normal playbackFrames pausing Frame-by-framePlaying still Slow motionNumber Searching by titleSearching by title number When chapter number 12 is input Searching directly by chapter or track numberPress ENT Playback starts from Selected title numberStart playback using Number keys 0 to Searching byElapsed time Searching by elapsed timeChapter/track/ DVD Video CD Title repeat playbackSwitching the angle DVD SwitchingSubtitles subtitle Language During playback, press Angle for at least SecondsDisplaying SubtitlesDisc status Displaying the subtitles Displaying the disc statusDisplaying the disc status Video output ON/OFF Only when CVA-1005E/IVA-C800E is connectedVideo output ON/OFF Changing the default settings setup Changing the language settingsStop mode, press SET for at leastSetup screen for the selected language is displayed Changing the language settingsPress SET for at least 2 seconds Changing the TV screen settings Changing the TV screen settingsUse the Joystick to make the selection, then press ENT Changing the country code setting Changing the country code settingPress ENT to reset the country code Use keys 0 to 9 to input Digit country code, then press ENTSetting the rating level parental lock Setting the rating level parental lockUse keys 0 to 9 to input the 4- digit password Use the Joystick to select the rating level, then press ENT Changing the down sampling setting Changing the down sampling settingSET UP on Select Down Sampling underPress SET for at least 2 seconds Changing the digital output setting Changing the digital output settingSelection, then press ENT Set up are stored and the set up mode is canceled Audio output/Optical digital audio outputChanging the LED indicator setting Indicator settingChanging the LED Custom setting Changing the Closed Caption Setting SET UP Custom setting Changing the Closed Caption settingPress SET for at Displays the closed captionsCustom setting Changing the Ai-NET settings Custom setting Changing the Ai-NET settingsUse the Joystick to select Ai- NET SETUP, then press ENT Use the Joystick to select DVD or CD, then press ENTCustom setting Changing the Ai-NET settings SET UP DVDCustom setting Changing the H.U Control settings Custom setting Changing the H.U. Control settingsSelect Custom Setup under Custom setting Changing the H.U. Control settings SET UP Operating Digital audio Processor optionalOperating the digital audio processor optional Press A.PROCAdjusting the parametric equalizer Adjusting the parametric equalizerAdjusting the surround settings Adjusting the surround settingsUse the Joystick to adjust the level LV, then press ENT Press ENT. The level LV value turnsSurround settings Storing the surround settingsUse the Joystick to adjust the time, then press ENT StoringRecalling the surround settings RecallingAdjusting Using the ProLogic mode Adjusting the time compensation Using the Pro Logic modeAdjust Setting the speaker mode Setting Speaker modeUse the Joystick to switch the mode Adjust Adjusting the acoustic image Adjusting Acoustic imageUse the Joystick to select the level item, then press ENT Mixing the rear Audio channels Adjust Mixing the rear audio channelsUse the Joystick to Select Rear MIX, then press ENT Center speaker Adjust Center speaker time compensationTime compensation Use the Joystick to select Rear DELAY, then press ENT Adjust Rear speaker time compensationRear speaker time compensation Achieving powerful Sound at low volumes Adjust Achieving powerful sound at low volumesUse the Joystick to select LISTENING, then press ENT Adjusting Speaker level Adjust Adjusting the speaker levelUse the Joystick to select Test TONE, then press ENT Use the Joystick to select ON, then press ENTAdjusting the volume, CD fader and balance Mode Adjusting the volume, fader and balanceUse the Joystick to select the speaker, then press ENT Adjusting Subwoofer Mode Adjusting the subwooferTurning the defeat function on and off Mode Turning the defeat function on and offOn The response is flat OFF Off Press Source and select CD DVA-5205E mode Operating from the head unitOperating from the head unit To set the pause mode, pressPress Title on the head unit Switch OperationDisplay pattern changes each time the button is pressed Operating from the head unit’s remote control unit Operating from the head unit’s remote control unitRemote Control RUE-4185 RUE-4160 Unit Operation Press Source , Audio SEL or A. SELto set the CD DVA-5205E ModeTo set the pause mode, press Or ENT SelectedTerminology TerminologySpeaker layout for enjoying Dolby Digital sound/dts sound List of language codes List of language codesFor details, see List of language codes List of country codes List of country codesList of country codes List of country codes Symptom Cause Remedy Case of difficultySpecifications NTSC/PALFunctions of remote control unit buttons Operating the DVA-5205E DVD Video PlayerPower Button → P10 DVD/AUDIO Switch → P8RPT Button → P19 GO to Button → P16, 17Operating audio for the Alpine Ai-NET Memo 13-38, Hinodai Hino, Tokyo, Japan Alpine Electronics of CANADA, INC