CHRYSLER-DODGE-PLYMOUTH Installation

CHRYSLER-DODGE-PLYMOUTHINSTALLATION

AllU.S.MadeCars,Trucks,andVansBuiltSince1974

Important-This radio cannot be installed in any U.S. made Chrysler, Dodge, or Plymouth without an installation kit. Refer to Kit Listings on page 2 for the required kit. Complete kit installation is explained in the instructions included with the kit.

CAUTION: 1. DO NOT CUT OR FILE THE OPENING TO THE OUTER EDGES OF THE TEMPLATE!

2.FOR PROPER OPERATION OF THE CD PLAYER, THE CHASSIS MUST BE WITHIN 20° OF HORIZONTAL. MAKE SURE THE UNIT IS MOUNTED WITHIN THIS LIMITATION.

1.RemoveExistingRadio:

A.Remove existing radio dash trim panel surrounding the radio opening. This panel is usually secured by screws and/or snap-in clips.

B.Remove the two large screws used to secure radio to the sub-dashboard.

Helpful Hint: If you do not have an existing radio, you will find the radio opening is covered by a disposable cover plate.

C.Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.

D.Un-plug the wiring harness(es) and antenna cable and remove the radio.

2.InstalltheNewRadio:

A.Following the instructions included with the installation kit, secure the sleeve from the radio to the mounting plate from the kit as explained on page 3.

B.Install the sleeve/mounting plate assembly to the sub-dashboard as per the instructions with the installation kit.

C.Replace the dashboard trimpanel.

D.Following the instructions of steps 4 and 5 on page 4, carefully wire the radio and complete installation into the mounting sleeve.

MOUNTINGPLATEFROMKIT	HELP!
(NOTINCLUDEDWITHRADIO)
SUB-DASHBOARD(RADIOAREA)

1-800-645-7102

Monday-Friday 8:30am-7:00pmEastern

Saturday 9:00am-5:00pmEastern

IMPORTANT

AMOUNTINGKITISREQUIRED

FORTHISINSTALLATION

FACTORYDASHPANEL

MOUNTINGSLEEVE

INSTALLRADIOUSINGSAME

PROCEDUREASEXPLAINED

ONPAGES3AND4

RADIO

REMOVALTOOLS	DETACHABLE
	FRONTPANEL

128-5272

6 of 20