Settingtheclock, Errorcodes | Audiovox ACD-32A instruction

OPERATING INSTRUCTIONS

3.If there is a malfunction of any of the switches on the unit or of the CD player, pressing the Re- Set button may clear the system and return to normal operation.

dnFRONTPANELRELEASEKNOB

This knob is used to release the mechanism that holds the front panel to the chassis. To detach the front panel, slide the button to the right so that the left side of the panel is released. Grasp the released side and pull it off of the chassis. To re- attach the panel, position the right side of the panel in place first and then press the left side of the panel until the mechanism locks it into place.

DETACHING THE FRONT PANEL

Release Button

NOTES ON USE OF FRONT PANEL

1.Make sure the front panel is right-side-up when attaching it to the chassis as it cannot be attached when up-side down.

2.Do not press very hard on the front panel when attaching it to the chassis. No more than light to moderate pressure should be needed.

3.When attaching the front panel, make sure the right side is correctly engaged before pressing the left side to lock it into position.

4.When taking the front panel with you, please use the supplied carrying case to protect the panel from dirt and damage.

ATTACHING THE FRONT PANEL

Engage right side first

SETTINGTHECLOCK

1.Turn the radio on so that the radio frequency or clock time is shown on the display panel.

2.Press and hold the Time/Frequency Display Selector button cu approximately 2 seconds until the time display begins flashing.

3.While continuing to hold the Time/Frequency Display Selector button, press the Down Seek Tuning

bp to adjust the hours and the “PM” indicator and the Up Seek Tuning button ( ) bobutton ( )

to adjust the minutes to the correct time.

4. When the correct time is shown on the display panel, release the Time/Frequency Selector button.

ERRORCODES

If a problem should develop while operating the CD player, the following error codes may be displayed on the display panel:

ER 1: Indicates the disc is not loading or ejecting properly. Try re-loading or pressing the Eject button again. Check the condition of the disc in use or try another disc.

ER 2: Indicates an interface error between the disc mechanism and radio circuitry. Press the Re-Set button dm and try again.

ER 3: Indicates an error in the laser reading the disc. Eject the disc, make sure it is clean, undamaged, and loaded correctly (label side up). Re-load the disc and check for proper operation or try another disc.

RST: Indicates a system error. Press the Re-Set button dm and try again.

ROM: Indicates that a computer CD-ROM has been loaded into the unit. Eject the disc and load an audio CD.

If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.

128-5272

16 of 20