Audiovox GM-250 owner manual Setting the Clock, BtRE-SETBUTTON

Page 5

btRE-SETBUTTON

A re-set button is located on the front panel which must be activated by a pen tip or other thin object as it is recessed to prevent accidental engagement. The re-set circuitry is provided to protect the microprocessor circuitry and should only be activated under the following circumstances as it will erase the time and station pre- set memories.

1.Upon initial installation after all wiring is completed.

2.If there is a malfunction of any of the switches on the unit, pressing the re-set button may clear the system and return to normal operation.

SETTING THE CLOCK

1.Switch the vehicle ignition “on” and the radio “on".

2.If the radio frequency is shown on the LCD panel bl , press the Time/Frequency Selector (T/F) bs momentarily so that the time display is shown.

3.With the time display on the LCD panel, press and hold the Time/Frequency Selector (T/F) bs for approximately 2 seconds until the time display begins flashing.

4. Within 5 seconds of the display beginning to flash, press the Down Tuning(

)

side of the button 7 to adjust the hours, then the Up Tuning (

) side of the

button to adjust the minutes to the correct time.

5.After setting the correct time, press the Time/Frequency Selector (T/F) again or wait 5 seconds for the display to stop flashing.

-4-

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Ownersmanual Radio and Cassette Controls Operating InstructionsAUTO-STORE Tuning AS PRE-SET Scan Tuning PS Manual UP/DOWN Tuning Seek TuningFM/AM Band Selector Station PRE-SET MemoriesBnFAST-FORWARDBUTTONFF BmCASSETTEDOORBoREWINDBUTTONREW BpPROGRAMSELECTORBtRE-SETBUTTON Setting the ClockDisc CD Changer ControlsCsTRACK/DISCSHUFFLESHF Error SignsCr TRACK/DISC Repeat RPT Audiovox Corporation, Hauppauge, N.Y Care and Maintenance
Top Page Image Contents