FORD-LINCOLN-MERCURY INSTALLATION -1984 AND OLDER
ImQortant- This installation is designed for 1984 and older U.S. made Ford cars, trucks, and vans. For newer vehicles, an installation kit may be required. See Kit Listing on Page 2 of this manual or refer to the
1.Renlove Existing Radio:
A.Remove radio knobs and shaft nuts behind the knobs.
B.Locate and remove support brace at back of radio.
C.Push radio back into dashboard to access the wiring and antenna cables plugged into the rear of the chassis Do
2.Wire the le. Radio:
Ao In most cases it is easier to wire the radio before mounting it. Place the r~dio near the dashboard so the wires can be led through the opening.
B. Carefully follow the diagrams on pages 10 and 11 or 12 (depending on how many speakers you are using) l to wire the radio, making certain all connections are secure and insulated with wire nuts or electrical tape to insure proper operation of the unit.
C. After completing the wiring, turn the unit on to confirm operation (ignition switch must be Non"). If unit does not operate,
3.Install the I.. Radilo:
A.Thread a shaft nut halfway down each radio shaft.
B.Place the nosepiece collar on the radio nosepiece.
C.Place the radio behind dashboard and through the radio opening. Adjust the position of the shaft nuts so that the radio nosepiece and collar are flush against the back of the dashboard.
D.Secure the radio with a shaft nut on each radio shaft.
E.Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or below
the radio using the screw and nut provided. Bend the strap to position it as necessary.
CAUTION: The rear of the radio mY§.tbe supported with the strap to prevent damage to the dashboard from the
weight of the radio or improper operation of the radio due to vibration. F. Install knobs on radio shafts.