Dell HR675 owner manual Installing System Components

Figure 3-16. Installing Diskette Drive Shoulder Screws

1

1 shoulder screws (4)

8From the front of the system, align the shoulder screws with the slot in the chassis, then slide the diskette drive into the drive bay until the shoulder screw snaps into place or you feel the drive securely installed (see Figure 3-15).

9Connect the power cable to the diskette drive.

10Connect one end of the data cable to the diskette drive connector on the system board (see Figure 6-1), then connect the other end of the data cable to the diskette drive.

11Replace the processor airflow shroud (see "Installing the Processor Airflow Shroud" on page 72).

12Replace the system cover (see "Installing the System Cover" on page 67).

13Replace the front bezel (see "Installing the Front Bezel" on page 64).

14Enter the System Setup program and ensure that the diskette drive’s controller is enabled (see "Entering the System Setup Program" on page 41).

Installing System Components

87