Dell HR675 Sata Port n drive, Not found, Sector not found, Seek error, Seek operation, Amount

Table 1-6. System Messages (continued)

Message	Causes	Corrective Actions
SATA PORT n drive	SATA port x was turned	See "Troubleshooting a Hard
not found	on in setup, but a drive	Drive" on page 153 for the
	was not found.	appropriate drive(s) installed
		in your system.
Sector not found	Faulty hard drive, USB	See "Troubleshooting a USB
Seek error	device, or USB medium.	Device" on page 138 or
		"Troubleshooting a Hard
Seek operation
		Drive" on page 153 for the
failed
		appropriate drive(s) installed
		in your system.
Shutdown failure	Shutdown test failure.	See "Troubleshooting System
		Memory" on page 146.

The amount of	Memory has been added
system memory has	or removed or a memory
changed	module may be faulty.

If memory has been added or removed, this message is informative and can be ignored. If memory has not been added or removed, check the SEL to determine if single-bit or multi-bit errors were detected and replace the faulty memory module (see "Troubleshooting System Memory" on page 146).

Time-of-day clock	Faulty battery or faulty	See "Troubleshooting the
stopped	chip.	System Battery" on page 143.
Time-of-day not set	Incorrect time or date	Check the time and date
- please run SETUP	settings; faulty system	settings (see "Using the
program	battery.	System Setup Program" on
		page 41). If the problem
		persists, replace the system
		battery (see "System Battery"
		on page 118).
Timer chip counter	Faulty system board.	See "Getting Help" on
2 failed		page 175.

36

About Your System