Dell HR675 owner manual Installing Optical or Tape Drive Shoulder Screws

Figure 3-19. Installing Optical or Tape Drive Shoulder Screws

1

1 screws (3)

8From the front of the system, align the shoulder screws with the slot in the chassis, then slide the drive into the drive bay until the shoulder screw snaps into place or you feel the drive securely installed (see Figure 3-18).

9Attach the SCSI power cable (see Figure 3-17) or SATA power cable (see Figure 3-18) to the drive.

10Attach the data cable:

•If you are installing a SATA optical drive (see Figure 3-18), connect the cable from the SATA connector on the drive to the appropriate SATA connector on the system board (see "System Board Connectors" on page 167).

•If you are installing a SCSI tape drive, connect the SCSI interface cable (see Figure 3-17) in the drive kit from the SCSI controller card to the drive.

11Replace the processor airflow shroud (see "Installing the Processor Airflow Shroud" on page 72).

92

Installing System Components