Dell HR675 owner manual 129

7Remove the SAS controller card, if applicable (see "RAID Battery" on page 99).

8Remove the internal USB memory key, if applicable (see Figure 6-1).

9Remove all memory modules (see "Removing Memory Modules" on page 111).

NOTE: Record the memory module socket locations to ensure proper reinstallation of the memory modules.

CAUTION: The processor and heat sink can become extremely hot. Allow sufficient time for the processor and heat sink to cool before handling.

NOTICE: To prevent damaging the processor, do not pry the heat sink off of the processor.

10Remove the processor (see "Removing the Processor" on page 114).

11Remove the SAS backplane, if applicable (see "Removing the SAS Backplane" on page 124).

12Carefully route any loose cables away from the edges of the system board.

13Pull up on the system board release pin, then slide the system board assembly toward the front of the system.

14Lift the system board out of the system.

Installing System Components

129