Dell HR675 PCIe Fatal Error, Caused a system, Reset Slot n, Embedded, Bus#nn/Dev#nn/Func, Remote

Table 1-6. System Messages (continued)

Message	Causes	Corrective Actions
PCIe Fatal Error	Faulty or improperly	Reseat the PCIe card in the
caused a system	installed PCIe card in the	specified slot number (see
reset: Slot n	specified slot.	"Installing an Expansion
Embedded		Card" on page 95). If the
		problem persists, see
Bus#nn/Dev#nn/Func
		"Getting Help" on page 175.
n
Please check the
system event log
for details
Plug & Play	Error encountered in	Install the NVRAM_CLR
Configuration Error initializing PCIe device;		jumper and reboot the
	faulty system board.	system. See Figure 6-1 for
		jumper location. If the
		problem persists, see

"Troubleshooting Expansion Cards" on page 159.

Read fault

Requested sector not found

The operating system cannot read from the hard drive or USB device, the system could not find a particular sector on the disk, or the requested sector is defective.

Replace the USB medium or device. Ensure that the USB or hard drive cables are properly connected. See "Troubleshooting a USB Device" on page 138, or "Troubleshooting a Hard Drive" on page 153 for the appropriate drive(s) installed in your system.

Remote	System unable to process	Retry Remote Configuration.
configuration	Remote Configuration
update attempt	request.
failed
ROM bad checksum =	Expansion card	Reseat the expansion card(s)
address	improperly installed or	and expansion card cables. If
	faulty.	the problem persists, see
		"Troubleshooting Expansion
		Cards" on page 159.

About Your System

35