Dell HR675 owner manual If the problem is not resolved, proceed to the next step, 139

cTurn off the USB device and swap the interface cable with a working cable. Turn on the device.

If the problem is resolved, replace the interface cable.

dTurn off the USB device, connect it to another USB connector on the system, and turn on the USB device.

If the USB device functions, the USB connector on the system is likely defective. Otherwise, the USB device is faulty and needs to be replaced. See "Getting Help" on page 175.

2Power down all USB peripheral devices and disconnect all USB devices from the system except the USB mouse and keyboard.

3Restart the system and reconnect the USB devices.

If the problem is resolved, the problem was likely caused by an overcurrent event on one of the USB devices. If the problem persists, attempt to isolate the faulty device by trying different USB configurations.

If the problem is not resolved, proceed to the next step.

4Reset the system BIOS to the default settings by setting the NVRAM _CLR jumper inside your system . Use the following procedure.

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.

aTurn off the system and attached peripherals and unplug the system from the power source.

bOpen the system. See "Removing the System Cover" on page 66.

cLocate the NVRAM_CLR jumper on your system board (see Figure 6- 1) and set the jumper to the enabled position.

dClose the system. See "Installing the System Cover" on page 67.

eReconnect the system and peripherals to power and restart. If all USB devices are operational, proceed to the next step.

If the USB devices are still not functioning, see "Getting Help" on page 175.

Troubleshooting Your System

139