Dell HR675 owner manual Installing System Components

NOTICE: Combining SATA and SAS hard drives in the same system configuration is not supported.

1Unpack the hard drive and prepare it for installation.

2Remove the front bezel (see "Removing the Front Bezel" on page 63).

3Remove either the existing hard drive, if applicable, or the hard drive carrier (see "Diskette Drive (Optional)" on page 84).

4Install the hard drive carrier on the hard drive.

a Insert the hard drive into the hard-drive carrier with the connector end of the drive at the rear. See Figure 3-12.

b Viewing the assembly as shown in Figure 3-12, align the screw holes on the hard drive with the rear set of holes labeled "SAS" on the hard drive carrier.

When aligned correctly, the rear of the hard drive will be flush with the rear of the hard-drive carrier.

cAttach the four screws to secure the hard drive to the hard-drive carrier. See Figure 3-12.

Installing System Components

79