DOS and Windows 3.1 Setup for Novell NetWare Clients
Important Note:
Windows 95 users and Windows NT should skip the procedure on this page and go directly to page 6 for Windows NT or page 8 for Windows 95. NetWare Client 32 users, go to page 10.
1Automatic configuration
PCI computers automatically detect and configure
Start your computer to automatically configure the adapter. Configuration is complete when the DOS prompt appears. You can now continue with the procedure below.
If your computer displays an error while booting, it may require additional steps to configure a PCI adapter. See the PCI installation tips section on page 17 for more information.
2Run Setup to install network drivers
Setup can automatically install NetWare DOS ODI client drivers for you or display a README file with installation instructions for other NOS drivers.
1If your computer already has network drivers installed, restart the computer without loading them. If the drivers are loaded from the AUTOEXEC.BAT or CONFIG.SYS file, type REM in front of each line that loads a network driver. Or, with DOS 6.x or later press 5 as DOS starts, to bypass the drivers.
2Insert the Intel Configuration and Drivers disk in a floppy drive, switch to that drive, and at the DOS prompt, type
S E T U P E
3If you have more than one Intel PRO series PCI adapter in your computer, an adapter selection menu appears on the screen. Select the adapter you want by noting the Ethernet address. See page 11 for more information on multiple adapters.
4Select Automatic Setup from the Main menu. Then follow the instruc- tions on the screen. (If you want to test the adapter with a responder on the network, see the next procedure.)
4
