Troubleshooting
If the adapter can’t connect to the network
Make sure the cable is installed properly.
The network cable must be securely attached at both
If you’re directly connecting two computers (no hub), use a crossover cable. Most hubs require a
See the Cabling Information README file for more information on cross- over cables.
Check the LED lights on the adapter.
The EtherExpress PRO/100 TX PCI adapter has three diagnostic LEDs above the cable connector. These lights help indicate if there’s a problem with the connector, cable, or hub. The table on the next page describes the LEDs.
Link LED
Activity LED
LNK
ACT
100 TX
100 Mbps LED
DATA
1 4