Table20. Removal steps of system board and fan assembly (continued)
When installing:
vBefore you attach the fan assembly to the computer,apply thermal grease, at
an amount of 0.2 grams, on the part marked a as in the following figure.
Either too much or too less application of grease can cause a thermal problem
due to imperfect contact with a component. Youneed to peel the thin film off
from the rubbers b.
For MT0196 and MT0492:
a
b
b
For MT0197:
a
a
vMake sure that the fan connector is attached firmly.
Removing and replacing a FRU 97