CD CHANGER CONTROLS
Built into this radio are controls to operate an optional CD changer. Please check with your Rampage/Audiovox car stereo specialist or call
To CDC Cable |
| To Radio CDC |
Connector | Connector | |
|
|
dp CD CHANGER PAUSE/PLAY SELECTOR ( PAU )
During radio, or CD player operation, press the MODE button to select operation of the CD changer. CDC will appear, disc play will begin, the disc and track number will be shown on the display panel, and the disc
icon ( 
) will become animated. If a new magazine has been loaded
into the changer, play will begin from the first track of the first disc in the magazine. If a magazine was already in the changer, play will resume from the track on the disc previously in play.
During CD changer play, pressing the PAU button once will stop changer play; PAUSE will appear on the display and the disc icon will remain stationary. To resume disc play, press the PAU button again and disc play will resume from the point at which it was interrupted.
3 | 2 |
4 | 1 |
|
1 | CD Left Input (Wht) | 1 |
2 | +12 Volts Acc (Yel) | 2 |
|
|
|
3 | CD Data Bus (Brn) | 3 |
|
|
|
4 | CD Audio Grd (Shld) | 4 |
1 | 2 | 3 |
4
5
dq & dr DISC SELECT (CD+/CD-)
These buttons are used to select the desired disc for play. To advance to a higher number disc, press the CD+ button dq. To return to a lower number disc, press the CD- button dr. The number of the disc in play will be shown on the display panel.
5
8
5 Data Bus Grd (Shld) 5 |
ds TRACK SELECT ( / )
6 7
DIN Connector
6 | CD Right Input (Red) | 6 |
| |
|
|
|
|
|
7 | Control Voltage (Blk) | 7 |
| |
|
|
|
|
|
8 | CDC On (Grn) | 8 |
| |
ISO Connector
This button is used to quickly select the beginning of a particular track.
With each momentary press of the Forward Track Select button (
), the next higher track number will be selected as shown on the display panel. Similarly, with each momentary press of the Backward Track
Once the changer is installed and properly connected, it may be necessary to press the RESET button behind the radio front panel to initialize the complete installation.
Adjustment of the audio functions (volume, tone, balance, and fader) for the CD changer operate in the same manner as they do for radio play. The following controls will operate the CD changer when it is installed and connected to this radio. Refer to the owner’s manual included with the CD changer for instructions on the installation and correct loading and use of the CD magazine.
Select button (
), the next lower track number will be selected.
dt FOWARD/REVERSE SEARCH (CUE/REVIEW)
button ( | ) to advance rapidly in the forward direction, or press | |
and hold the reverse (review) button ( | ) to advance rapidly in the | |
reverse (backward) direction. In either case, the disc icon will rotate faster when search is active.
12 of 16